
CONNECTING TO POWER
1.
Insert one end of supplied power cord into the socket marked
DC 5V/2A
located on the side
of the clock and the other end into the wall mains power outlet.
2.
Please only use the supplied mains power cord or a cable that supplies 5 volts & 2 amps.
Over supply of power will cause immediate damage to your clock radio.
3.
If the clock is not powering up please check that the power cable is fully inserted into the
socket on the side of the clock. On first use the plug may need to be quite firmly pressed in
to place.
4.
The display should now be on and on initial use time will be flashing, indicating that your
clock radio is powered on, in standby mode and waiting to have the time set.
BACKUP SYSTEM
1.
The clock is equipped with a backup system. It requires 2 x AAA batteries. Insert the
batteries into the battery compartment and make sure the positive and negative (+ or -)
sides of the batteries are in contact with the corresponding terminals in the battery
compartment.
2.
In the event of power failure or disconnection of the power cord, the power supply is
automatically switched to the backup battery, keeping the time and alarm settings. Time will
not be displayed when using battery backup.
3.
When replacing the battery, do not disconnect the power adapter. Otherwise, all clock and
alarm settings will be lost.
SETTING THE TIME
1.
In standby mode, press and hold the
TIME/PRESET
button for 1-2 seconds to enter TIME
SET mode. When clock enters TIME SET mode it will display the letters / digits
12H
flashing
on screen.
2.
Press the
HOUR/TUN-
or
MIN/TUN+
button to select 24H or 12H (12-hour or 24-hour time
display.) Then press
TIME/PRESET
button to confirm. The time will now be flashing on the
display.
3.
Press the
HOUR/TUN-
button to set the hour and
MIN/TUN+
to set the minute. Press and
hold the
HOUR/TUN-
or
MIN/TUN+
button to move quickly.
4.
Press
TIME/PRESET
button to confirm the correct time is set. Time will now stop flashing
and your clock setup is complete.
Содержание WM3020i
Страница 1: ...AIC WM3020i ...