Ahlborn ALMEMO 8590-9, Руководство по эксплуатации

Страница: 5 / 28

3. General
5
⚫
The device is used in environments and conditions for which it is not suited.
⚫
The device is used with unsuitable power supply equipment and peripherals.
⚫
The device is used for any purpose other than that for which it is intended.
⚫
The device is damaged by electrostatic discharge or lightning.
⚫
The user fails to observe and respect the operating instructions.
The manufacturer reserves the right to change the product's characteristics in
the light of technical progress or to benefit from the introduction of new compo-
nents.
3.2 Scope of delivery
When you unpack the device check carefully for any signs of transport damage
and that delivery is complete.
Measuring instrument ALMEMO
®
8590-9 or 8690-9A
Mains adapter
These operating instructions
In the event of transport damage please retain the packaging material and in-
form your supplier immediately.
3.3 How to deal with rechargeable batteries
Usually when the device is delivered the batteries have not yet
been charged. First of all therefore the batteries should be charged
using the mains adapter provided; continue charging until the
CHARGE
lamp goes out.
Rechargeable batteries must never be short-circuited or thrown on
the fire.
Rechargeable batteries are special waste and must not be dis-
carded together with normal domestic waste.
3.4 Special notes on use
⚫
If the device is brought into the work room from a cold environment there is
a risk that condensation might form on the electronics. In measuring opera-
tions involving thermocouples pronounced temperature changes may cause
substantial measuring errors. You are advised therefore to wait until the de-
vice has adjusted to the ambient temperature before starting to use it.
⚫
Before using the mains adapter make sure that the mains voltage is suitable.
⚫
Be sure to observe the maximum load capacity of the sensor power supply.
⚫
Sensors with integrated power supply are not electrically isolated from one
another.
⚫
Do not run sensor lines in the vicinity of high-voltage power cables.
⚫
Before you touch any sensor lines, ensure that all static electricity has been
discharged.