Ahlborn ALMEMO 6290-7B, Руководство по эксплуатации, Страница: 36 / 53

Loading the Temperature-Sensitive Paper
Only the temperature-sensitive paper that is specified for this printer must be
used to ensure high quality printing and safe operation. To remove the cover,
pressure must be applied to the grooved surfaces on both sides and the cover
must be pulled upwards. The temperature-sensitive paper must be cut straight
before insertion. It must then be pushed into the slot at the front side of the
paper compartment and the key
PAPER FEED
must be pressed until the paper is
coming out from the print head. To protect the paper roll from falling out and
from contamination, the cover must be mounted and locked by pressing on the
side surfaces. A red stripe will appear on the paper to indicate that the paper is
running out. The remaining paper should be pulled out and replaced with a new
paper roll.
8.3 Printing
For alphanumerical printouts the output mode ´
OM
´ must be set to PRINT ´
dr
´
(see 8.1).
8.3.1 Programming
The key
START/STOP
can be used to start two control printouts for the
programming:
Within the function output mode ´
OM
´ or baud rate ´
BR
´:
Sensor programming and process control (see program header, 8.3.2),
Within the function device address ´
A
´ or atmospheric pressure ´
mb
´:
Programming of the instrument (see 8.5.3).
8.3.2 List of Measured Values
If, within function MEASURE and with the output mode set to ´
dr
´ , a
measuring point scan is started by using the key
START/STOP
(see 7.2), a list of
measured values with time and all measured values is printed out.
If the print cycle is cleared (
00:00:00 PC
) only the values of one single
measuring point scan are available. Up to 2 channels are printed in columns
in each line. If there are more channels, they will be printed below.
Printout of one single measuring point scan:
12:50:05 1: + 29,31 °C 2: + 965.7 mb
3: + 51,8 %H
If the print cycle is programmed (see 7.2.3), a list of measured values from the
cyclic measuring point scan is available.
As the built-in printer needs almost 2 seconds for printing a line
with 2 measuring points the print cycle must be selected
accordingly (at min 2 sec. for 2 meas. points, at min. 4 sec. for 4
meas. points etc.).
35 ALMEMO

6290-7B
Digital Data Output