Ahlborn ALMEMO 3290-8 V5, Руководство по эксплуатации

Страница: 35 / 48

An averaging process for the measured values of measuring point scans can
be programmed for each measuring point (manual 6.7.4).
The average value
can be indicated and programmed at switch setting AVG VAL. Average
values must be cleared before each measurement and for programming.
The
clearing of an average value is performed after selecting the input
channel by using the keys
ENTER
,
Clr
or by a total clearing (see 7.).
Avg. Val : AVG VAL. Clear: ,
ENTER
Clr
1: - - - -
°C
The type of averaging is determined through the averaging mode. This
function (AM) is activated by using the key
FUNCTION
.
Averaging mode: AVG VAL.
FUNCTION
1: C o n t
AM
The following modes can be set by using the keys
ENTER
,
×Ø
,
ENTER
:
Function Display
No averaging:
- - - -
Continuous averaging:
C o n t
Cyclic averaging:
C Y C L
For averaging single measurements the averaging mode ´ Cont ´ must be
selected, measuring and print cycle must be cleared and the key MANUAL must
be pressed each time. In function AVERAGE the average value is indicated
and can be printed at any time by using the key
OUTPUT (see 8.3).
For an averaging over time the measuring and, possibly, print cycle must be
programmed in addition to the averaging mode. For starting the averaging the
key START/STOP must be operated and for stopping the key START/STOP must
be operated once again. The arrow ´
AVERAGE
´ will be indicated on the display if
a channel is subject to averaging.
The count C of averaged values can be obtained in function C by operating
the key FUNCTION twice.
Count C : AVG. VAL. ,
FUNCTION FUNCTION
1: 0 1 2 3
C
ALMEMO

3290-8 35
Data Memory