Ahlborn ALMEMO 3290-8 V5, Руководство по эксплуатации

Страница: 31 / 48

7.3 Cyclic Measuring Point Scan
(see manual 6.5.1.2)
For cyclic measuring point scans the measuring or print cycle (see 7.3.1/2)
must be programmed. The measurement is started with the key
START/STOP
and the arrow ´ START ´ is continuously indicated. If the memory is active (see
7.4.1) the measured values are stored and the arrow ´
MEMORY
´ is indicated. If
a peripheral device is connected, the measured values are provided as a cyclic
output and, in addition, the arrow ´
RS232C ´ is indicated. Different output formats
are available (see 7.3.1). The measurement must be started in the function
RANGE if the programming is to be indicated before the measured values. The
corresponding print outputs can be found in manual section 6.6.1.
Start Cyclic Meas. Point Scan: Key:
START/STOP
Stopping of the automatic measuring point scan can be achieved by
operating the key
START/STOP
once again. The indications ´
START
´, ´
RS232C
´
and ´ MEMORY ´ will disappear.
Stop Cyclic Meas. Point Scan: Key:
START/STOP
7.3.1 Print Cycle, Output Channel, Output Format
The print cycle, the output channel and the output format can be set in the
function OUTP. CYCLE for cyclic measuring point scans and outputs.
Function:
Print cycle
Output channel
Output format
OUTP. CYCLE
Example: print cycle 30 min, output channel ´
U
´ (V24), column format.
The print cycle is programmed with 6 digits in the format hh:mm:ss (see 5.3).
Clear print cycle: Keys: ,
ENTER
Clr
0 0:0 0:0 0
n U
A running cyclic scan is terminated by this.
The output channel allows to select whether the measured values are
provided as output to the interface or to the memory. However, for storing all
measuring point scans the memory activation in the measuring cycle can also
be used (see 7.3.2).
0 0:3 0:0 0
n U
ALMEMO

3290-8 31
Cyclic Measuring Point Scan