AgXcel Muller ISO, Быстрая настройка

Страница: 12 / 17

WWW.AGXCEL.COM 877-218-1981
info@agxcel.com
Page | 12
Quick Start Setup Instructions for Müller RCM ISO -
Single Product
AgXcel GX5 Hydraulic System

What is your system pressure? If system pressure is too high (90PSI or above) this will prevent you from achieving your
highest rate possible. High system pressure with a hydraulic system set 100 PSI bypass spike valve to open and you could begin to
lose volume

Check the following areas to lower your pressure
 Select a larger orifice or Micro Tube with a larger hole, this will allow for easier flow of liquid through the
system and can increase over all flow and GPA

Check your system filters and make sure they are clean. This should be a practice each morning before using
the system

Check your total GPM requirements and ensure that you are within range of the GX5 hydraulic pump ’ s recommended
GPM

Ensure that your PWM High Limit is set to 100. Many times, an Auto Tune will set this to a lower number so make sure
this is set to 100

If you controller has this option, make sure the PWM Duty Cycle is within range

Check all your boom widths and make sure that all are set correctly
My rate is fluctuating and is almost locking in but is jumping around

Make sure that your Rate Smoothing is checked and set to 10. You can typically find this setting under your System
Controller settings. Rate Smoothing allows the system to lock into the rate if the rate is within 10% of the required rate. M any
times, liquid temperature can affect the performance of the system.

Make sure your pressure is enough to fully OPEN every check valve on the implement. A good rule of thumb is to
ensure that pressure is higher than 15 PSI when using 4lb, 5lb and especially 10lb check valves .
How do I know where my pressure should be?

AgXcel systems are not pressure based especially when they are controlled with a Liquid Rate Control Module.
HOWEVER, pressure can affect the performance of the system if the pressure is too low or too high. Many users feel that the
higher the pressure then the less chance they have to plug an orifice. Although this statement holds value it can also have a
major effect on system performance
.

Low pressure – RECOMMENDED 15PSI is the lowest

Can affect the performance of the pump and may cause it to surge which affect the accuracy of your flow
AGXCEL LIQUID SYSTEM FREQUENTLY ASKED QUESTIONS (FAQ) CONTINUED
AGXCEL,
LLC