Agu PMBF2, Руководство пользователя, Страница: 63 / 92

EN 63
The «Warm water»
button is flashing,
and the machine
does not respond to
any buttons pressed There is no water
in the system or
the water is too hot Check if there is water in the water tank
and press the «Warm water» button
− the
machine will check all water feed systems
The display
does not light up
The device
is not turned on
Check O/I switch, make sure that it is
switched on
The control panel
cable is damaged
or disconnected
Check the cable continuity.
Check if the cable is plugged into the outlet
Leakage of water
on the surface of the
funnel
The funnel is not
installed correctly
Reinstall the funnel
During the baby
formula preparationis
only water poured (the
machine «prepares»
only water) The container for
the mixture is not
installed correctly Make sure that the container is installed
in such a way that the container ledge
coincides with the groove (slot) on the
main unit, as shown on Picture 1, item 2
(2.1
–2.6). Ensure that the container is
firmly seated in the block, and that the
teeth of the container shaft and the main
unit do not hit each other (are in bond).
If necessary, rotate the container shaft
manually and reinsert the container.
Check if the container for the mixture is
correctly assembled.
Make sure that the ledge of the funnel lid
coincides with the groove on the funnel
body, as shown on Picture 1, item 7.
Make sure that the funnel is firmly seated,
until it stops in the block
During the
preparation of the
formula is only
a dry milk mixture
poured (the machine
«prepares» only
the mixture)
The water is over
Fill the container with water, not exceeding
the MAX mark
The water tank
is not installed
correctly
Make sure that the ledge on the body
of the water container is firmly inserted in
the groove (slot) on the main unit case and
is inserted into the lower base on the main
unit until it stops.
Press button «Warm water» to check
the water supply. Repeat until the water
begins to flow normally