Agromehanika AGS 2500 EN-HP, Инструкция по эксплуатации

Страница: 29 / 131

AGS 2500/3000 EN-HP USER MANUAL – rev.2016/12
page
19
6
DRIVE – CARDAN SHAFT (NOT INCLUDED)
6.1 Safety of the user
WARNING: To avoid accidents and personal injuries, follow these
recommendations and safety regulations!

Before mounting (connecting of the cardan shaft to the tractor and the
sprayer
) the
drive shaft – cardan shaft, always turn off the engine and remove the start key
from its lock .

When mounting the cardan shaft, the cardan shaft of the tractor can be easily turned if
the engine and the cardan shaft is turned off.

When mounting the cardan shaft make sure that the safety pin is securely locked. Pull
and push the cardan shaft forwards and backwards until the safety pin locks into place.

Rotating shafts without protection can be very dangerous!

Always make sure that all of the safety devices are on their place and that all of the
rotating surfaces are well covered, including the "joints" of the cardan shaft on both
ends! Do not use cardan shafts without protection!

Do not touch rotating cardan shafts! The safety distance to a rotating cardan should not
be less than 1.5 m.

Secure protection elements with chain from turning!

Make sure that the protection of the cardan on the tractor and connection is well
connected (attached)!
6.2 Connection of cardan shaft
Procedure of first cardan shaft installation:
1. Mount the
sprayer
to the tractor.
2.
Stop (turn off) the tractor’s engine and remove the start key from the lock (start).
3. Use the cardan shaft to connect drive output shaft of the tractor and input shaft on the
sprayer's pump.
4. If the cardan shaft is too long and needs to be shortened, pull out the cardan shaft and
mount each end of it separately to the shaft of the tractor and to the shaft of the sprayer,
measure it out and mark the place where it needs to be cut.
5. Use an appropriate tool to shorten both parts in the same way and remove sharp edges.
6. Attach profiles and connect both parts of the cardan shaft.