Agromehanika AG-TRONIK S1, Инструкция по эксплуатации, Страница: 50 / 50

AG-TRONIK
50
11. MAINTENANCE
•
After each spraying, the regulator must be thoroughly washed with clean water, because only
this helps to keep the regulator in good condition, operation errors are fewer, which reduces the
costs of service.
•
Occasionally clean the external part of the regulator and grease rotating and sliding parts. Most
appropriate agent is WD-40 or similar maintenance agents.
•
During winter, all water must be emptied out of the regulator, the valves must be left open or
keep the regulator in a warm place. If you fill the sprayer during winter with antifreeze or agent
against freezing of windows, open valves and buttons on valves to prevent freezing in dead,
inaccessible places of the regulator.
•
It is obligatory to unscrew the manometer and keep it in a warm place.
12. SETTING THE PARAMETERS IN THE AG-TRONIK
•
Technicians of Agromehanika input parameters, required for spraying in AG-tronik and save
these parameters in factory setting. AG-tronik is accompanied with a sheet of parameters –
settings, input as factory settings.
•
If the speed sensor is installed subsequently or you have installed a speed sensor on tractor
wheel, then the parameter of speed constant is unknown and has to be input manually.
PARAMETER VALUE NOTE
Imp/l
D1
D2
D3
D4
D5
D6
D7
D
Imp/km
l/ha