Agromehanika 12 HLX, Инструкция по эксплуатации

Страница: 75 / 128

INSTRUCTIONS FOR USE
AGS 1800 - 2000 EN-HV (HVB) Rev.9/2018
74
12.4.8 SETTING SPEED OF HYDRAULIC CYLINDERS
Figure 12.37
Hydraulic cylinders are equipped
with double blocking valve (2) and
damper (3 The double blocking
valve maintains the position of the
hydraulic cylinder (1) and provides
protection against closing/opening
in the event of damage to hydraulic
hoses. Damper sets speed of
hydraulic
cylinder. Spraying
equipment is set so that one
working cycle of opening or
closing of one boom lasts 25 s.
12.5 OPERATION DESCRIPTION
Handling of equipment can be done if the sprayer with the sprayer equipment is properly connected to
tractor (see chapter "CONECTION SPRAYER TO TRACTOR"). Connect hydraulic hoses of sprayer
to hydraulic connections of tractor and connect control panel for controlling hydraulic equipment.
Control of spraying equipment is performed on a flat surface and tractor at standstill.
12.5.1 OPENING OF SPRAYING EQUIPMENT
Handling is done through control panel and functions, described in chapter 12.2.1. When opening
equipment from transport to working position, first activate blocking switch (red indicator), then lift
spraying equipment with switch for lift to position of activation of mechanism with wheel (see chapter
"MECHANICAL
SAFETIES FOR CONNECTION OF SPRAYER AND SPRAYING
EQUIPMENT"), then start opening booms and activate switch for right or left side. Indicator lights red
for activated side. Use handles on the tractor to lower the right and then left side of booms or vice
versa. This releases mechanical safeties against opening booms in transport position. Release block
(indicator off). Use switch for hydraulic levelling to level spraying equipment and lower it appropriate
height with lift switch.
WARNING: Opening and closing of hydraulic spraying equipment should not be
done while driving, because overturn or damage to spraying device can occur.