12
6. While holding the unit firmly, pull out the starter
rope quickly until engine fires.
WARNING
The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
rotate as soon as the engine is started by putting
the throttle into the start position. When starting the
engine, place the product onto the ground in a flat
clear area and hold it firmly in place so as to ensure
that neither the cutting part nor the throttle come
into contact with any obstacle when the engine
starts.
IMPORTANT
•
Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7.
Move the choke lever downward to open the choke.
And restart engine.
8. Allow the engine to warm up for a several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after
stopping it, leave the choke open.
2.
Over choking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
STOPPING ENGINE
START
Stop
Start
Ignition switch
1.
Release the throttle lever and run the engine for half
a minute.
2.
Shift the ignition switch to the STOP position.
IMPORTANT
•
Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
ADJUSTING THROTTLE CABLE
•
The normal play is 1 or 2 mm when measured at
the carburetor side end. Readjust with the cable
adjusteras required.
(1)
(1) Cable adjuster
.04 in
(1-2 mm)
ADJUSTING IDLING SPEED
(1) Idle adjusting screw
(1)
1. When the engine tends to stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after
releasing the trigger, turn the adjusting screw
counter-clockwise.
