Agria 0900 041, Оригинальная инструкция по эксплуатации

Страница: 20 / 40

20 agria Power Hoe 900 / 900-S
3
3. Devices and Operating Elements
F
1 Hex nut
2 Washer
3 Extension guard
4 Bolts
5 Guard discs
6 R-clip
7 Add-on hoeing tool, right
8 Hex bolt
9 Base hoeing tool, right
10 Base hoeing tool, left
11 Add-on hoeing tool, left
S = Blade
45cm working width 65cm working width
Hoeing Tools
45 cm working width:
l
Fit the hoeing tools in the same way
as described in 28 cm working width.
l
Fit the add-on tools (F/7 + 9) in the
hubs of the base tools.
l
Insert the bolts (F/4) into the holes in
the hub and secure them with R-clips
(F/6).
65 cm working width:
l
Fit and attach the second add-on tool
(F/7 + 9).
l
Attach the extension guards (F/3)
using attachment bolts (F/1, 2 + 8).
Guard discs
The discs are to prevent shrubs and
bushes from being damaged by the hoe
and to protect young plants from being
covered with soil. In addition, they offer
protection for the operator when hoeing
along field edges or fences.
l
Fit the guard discs (F/5) in the outer
hubs on the hoeing tools.
l
Insert the bolts (F/4) into the holes in
the hub and secure them with R-clips
(F/6).
Working width:
Base hoeing tools: ....... approx. 28 cm
Base hoeing tools and
1 add-on tool: ............... approx. 45 cm
2 add-on tools: ............. approx. 65 cm
Fitting the hoeing tools
W
Only fit/remove the hoeing
tools while the engine is shut
off and the spark-plug connector is re-
moved!
Wear safety gloves!
28 cm working width:
l
Fit the base hoeing tools (F/9 and
F/10) onto both ends of the hoeing shaft.
Ensure that the blades point into travel-
ling direction. When fitting the second
hoeing tool (either left or right), make
sure the knives pointing to the housing
are fitted in a staggered way to the
knives fitted on the opposite end of the
shaft.
l
Fit hoeing tools with bolts (F/4). In-
sert the bolts into the holes in the hub
and secure them with R-clips (F/6).