Agri-Fab VAC-N-GO 45-0407-131, Руководство пользователя

Страница: 11 / 24

11
1/4" DOWN
Keep cut-off as close to
the top edge as possible.
IMPORTANT:
1/2" FROM FRONT
FIGURE 14
ASSEMBLING THE #62468 DECK ADAPTER
TO THE MOWER DECK
CAUTION:
Mower defl ector must be replaced
when Vac System deck adapter is removed. Do
Not operate mower unless adapter or defl ector
is in place and properly mounted.
NOTE:
Not all of the parts in the deck adapter hardware
package will be used for any one particular fi t up.
1. Remove the mower discharge defl ector from your mower
deck. Save the defl ector and hardware for remounting
defl ector.
If you have a Murray brand tractor with a 38", 40" or 46"
deck, go directly to the instructions on page 13.
2. Identify and cut out the template for your
brand and
size
mower deck. If there is no template included for
your deck size, you can make your own template by
marking around a piece of card board held against the
edge of the deck's discharge open ing.
3.
FOLLOW THE INSTRUCTIONS PRINTED ON THE
TEM PLATE.
If there are no in struc tions, use the fol low ing
in struc tions as a general guide.
4. Tape the template to the face of the adapter, about
1/2" from front and 1/4" down from top for deeper decks.
For shallow decks, position tem plate low enough that
adapt er will not extend below bottom of deck. Mark outline
of tem plate on face of adapt er using white crayon, nail
or scriber. Drill a starting hole inside the outline, then
use a saber saw or key hole saw to cut out the opening.
See fi gure 14.
MOWER DECK
DECK ADAPTER
NOTE: Make sure adapter clears gauge
wheels on mower deck
Curl on deck may be located outside of adapter
or inside depending on deck opening design
DECK ADAPTER
MOWER DECK
ADAPTER BRACKET
Keep edge of adapter as close
as possible to offset in bracket
Use existing holes or drill 5/16"
diameter hole or holes.
5. Position the adapter over the deck opening, and check
for fi t of cutout as shown in fi gure 15. Trim cutout, if
necessary, to allow tilting of adapter, keeping the fi t as
close as possible for best vacuum suction.
6. Holding the adapter bracket and the deck adapter
together, position the deck adapter on the mower deck.
Keeping the edge of deck adapter as close as possible
to the offset in the adapter bracket, see if the slot in the
adapter bracket can be aligned with one or two of the
defl ector holes in your mower deck’s discharge opening.
If the bracket can not be located correctly using existing
holes, it will be necessary to drill one or two 5/16"
diameter holes in the deck. See fi gure 16.
FIGURE 15
FIGURE 16