Agri-Fab LST 42A, Руководство пользователя

Страница: 16 / 28

16
INSTALLING THE ATTACHMENT PIN
11. Lift the front of the snow blower to align the holes in
the mounting plates and the side plates. From the left
side of the tractor install the attachment pin through the
holes, securing it with the 1/8" hairpin cotter. Refer back
to fi gure 29 on page 15.
SETTING THE AUGER BELT TENSION
12. Pull the tensioning chain until the end of the spring is
pulled through the hole in the side of the Clutch/Idler
assembly. Install the 1/8" hairpin cotter through the end
of the spring, securing it on the outside of the Clutch/Idler
assembly. See fi gure 32.
IMPORTANT:
For correct belt tension, the 1/8" hairpin
cotter
must attach
to the end of the spring,
not
to the
chain.
Hold this drawing above you while viewing the
Clutch/Idler Assembly from underneath the
tractor. Right and left in the drawing will be the
reverse of the viewer's right and left.
FIGURE 32 VIEWED FROM UNDERNEATH
CHECKLIST
Before you operate your snow thrower, please review the
following checklist to help ensure that you will obtain
the best performance from your snow thrower.
1. All assembly instructions have been completed with all
bolts and nuts properly tightened.
2. Check the engine belt and the auger belt. Make sure
they are routed properly around pulleys and inside all
belt keepers.
3. Check discharge chute for proper rotation.
4. Check operation of tilt control for upper chute.
5. Verify that the lift handle will lock into and release from
the raised transport position. (Refer to the Service and
Adjustments section.)
6. Check skid shoe adjustment. (Refer to the Service and
Adjustments section.)
Operating instructions begin on page 17.
END OF
SPRING
1/8"
HAIRPIN
COTTER
LEFT SIDE
OF
TRACTOR
FLAT
PULLEY
INSTALLING THE REAR REFLECTORS
13. If your tractor is not equipped with rear refl ectors,
assemble the supplied rear refl ectors to the rear fender.
Place the refl ectors as close to the bottom of the fender
and as far apart as the shape of the fender will allow.
See fi gure 33.
FIGURE 33
REAR REFLECTORS