Agri-Fab 45-0545, Инструкция по эксплуатации

Страница: 9 / 16

9
FIGURE 20
27. Attach the tongue to the frame assembly tube using a
1/4" x 1-3/4" hex bolt (D), two 1/4" flat washers (Q) and
a 1/4" nylock nut (J). Repeat for the other side.
Do not
tighten yet. See figure 20.
28. Attach the tongue to the center brace (15) using two
1/4" x 5/8" hex bolts (F) and 1/4" nylock nuts (J).
Repeat for the other brace.
Do not tighten yet. See
figure 20.
29. Assemble the plastic grip (Z) onto the end of the flow
control arm (6). See figure 21.
30. Insert the flow control arm (6) through the slot in the
hopper brace (4). Place a nylon washer (R) on each
side of the arm and attach it to the brace's welded
bracket using a 1/4" x 1-1/4" hex bolt (C), a 1/4" flat
washer (Q), and two 1/4" nylock nuts (J).
Tighten
the first nylock nut until there is noticeable resistance
when moving the flow control arm, then
tighten the
second nylock nut. See figure 21.
31. Place the flow control rod (7) through the hole at the
end of the flow control arm (6). Assemble the two
ferrules (CC) onto the threaded ends of the rod so
that approximately 10 threads (1/2") of the rod extends
through the ferrules. See figure 21.
FIGURE 21
26 Assemble the end of the tongue (9) to the hopper using
two 1/4" x 5/8" hex bolts (F) and 1/4" nylock nuts (J).
The holes are located just below the frame assembly
tube.
Do not tighten yet.
See figure 19.
FIGURE 19
FIGURE 18
25. Attach the lift tube assembly (11) to the spreader using
the two shoulder bolts (I) and two 3/8" hex lock nuts
(M). See figure 18.
I
M
11
J
F
9
FRAME ASSEMBLY TUBE
J
J
F
Q
D
15
R
J
Q
C
Z
CC
7
6
4
1/2"