10
FIGURE 25
39. Assemble the flow control gauge (5) to the hopper
brace using the 1/4" x 3/4" carriage bolt (G), a nylon
washer (R) and the plastic knob (X). See figure 25.
34. Insert a tongue brace (8) through the slot in the end
plate. Fasten the front hole of the tongue brace to the
end plate using a 1/4" x 5/8" hex bolt (F) and 1/4"
nylock nut (J). For the rear hole use a 1/4" x 3/4" hex
bolt (E), 1/4" flat washer (Q), and 1/4" nylock nut (J),
with the bolt and washer assembled from inside the
hopper.
Do not tighten yet.
See figure 23.
35. Fasten the other end of the tongue brace (8) to the
side of the tongue using two 1/4" x 5/8" hex bolts (F)
and 1/4" nylock nuts (J).
Do not tighten yet.
See
figure 23.
36. Repeat steps 10 and 11 for the second tongue brace.
37.
Tighten
all bolts and nuts assembled so far.
FIGURE 23
FIGURE 22
32. Attach the hopper brace (4) to the hopper using two
1/4" x 5/8" hex bolts (F), one 1/4" flat washer (Q),
and two 1/4" nylock nuts (J).
Do not tighten yet.
See
figure 22.
33. Place the end of the hitch bracket (10) with two holes
down through the slot in the tongue. Attach the hopper
brace to the top of the tongue and the hitch bracket to
the bottom using one 3/8" x 1" hex bolt (B) and one
3/8" nylock nut (L).
Do not tighten yet.
See figure 22.
38. Assemble a 1/2" x 4" hex bolt (A), a 1/2" washer (P),
a wheel, a 1/2" washer (P), and a 1/2" jam nut (N).
Finger tighten only.
Attach the wheel assembly to
the transport tube using a 1/2" nylock hex jam nut (S).
Repeat for the other side. See figure 24.
FIGURE 24
A
P
P
N
S
L
F
B
Q
J
4
10
F
J
F
J
8
E
Q
J
X
R
G
5
