13
STEP 22: (SEE FIGURE 20)
• Attach the clutch/idler assembly to the tractor frame.
Hook the notched rear pulley frame brackets onto the
two shoulder bolts assembled to the outside of the
tractor frame. Lift the front of the assembly and attach
it to the R.H. and L.H. hanger brackets using two pivot
lock pins and 1/8" hairpin cotters.
PIVOT LOCK PIN
(use second hole)
SHOULDER
BOLT
1/8" HAIRPIN
COTTER
L.H. HANGER
BRACKET
FIGURE 20
VIEWED FROM LEFT SIDE
STEP 23: (SEE FIGURE 21)
• Assemble the drive belt onto the engine pulley. You
may need to remove the belt from the large pulley on
the clutch/idler assembly in order to assemble it onto
the engine pulley. When re-assembling the belt onto
the large pulley, be sure the belt is between the large
pulley and the hex bolt next to it.
• Place tension on the belt by pulling the left side
tensioning chain out as far as the 3/32" hairpin cotter
that was installed in the chain in step 17 will allow.
Secure the chain in this position by inserting a 1/8"
hairpin cotter through the chain.
NOTE;
To prevent the chain from dragging on the
ground, loop the end of the chain though the pivot lock
pin. Refer to figure 31 on page 16.
•
Go to step 24 on page 14.
FIGURE 21
VIEWED FROM UNDERNEATH
1/8"
HAIRPIN
COTTER
ENGINE
PULLEY
HEX BOLTS
FLAT IDLER
PULLEY
TENSIONING
CHAIN
LEFT SIDE
OF TRACTOR
