AGRI EASE BE-WC42G, Руководство по эксплуатации и запасным частям

Страница: 7 / 12

STATIONARY KNIFE SETUP BE-WC42G
After sharpening rotor knives, stationary knife may need to be set up. Loosen knife and set up with rotor knives
to 1/32” clearance to the nearest knife. Always check clearance with all knives before tightening and using.
LUBRICATION SCHEDULE
PTO Model:
1. Greaseable bearings (2) on rotor shaft (20 Hours).
2. Greaseable bearings (2) on PTO shaft (20 Hours).
3. Lubricate telescoping tubes on PTO shaft for operator ease.
CLEARING PLUGGED ROTOR
If too large a material or too much material is fed into the chipper, it could plug the rotor.
To clear the rotor, proceed with the following:
If
Wait for rotor to come to a complete stop!
Keep hands clear of blades!
Never start tractor with rotor housing open!
Hopper must be down in operating position
with lock nuts tightened to use the chipper!
1. Disengage PTO and shut off tractor engine.
2. Remove rotor access cover belt, lift rotor access cover.
3. Clean the debris out of the chipping rotor, turn the rotor by hand to be sure it is free.
4. Replace rotor access cover and tighten rotor access bolt.
5. Start tractor, engage PTO and resume operation.
SHEAR BOLT REPLACEMENT
PTO models are protected by a shear bolt on main rotor shaft. If shear bolt shears remove broken shear bolt
and install replacement shear bolt.
For operator safety, never use a harder grade of shear bolt than recommended.
Nuts must be tightly fastened
before starting chipper!