AGRETO VibroCounter
© AGRETO electronics GmbH
page:6
Option B
Drill the 2 holes with a 5.5mm diameter drill and deburr the 2 holes.
Hold the threaded plate against the back of the holes. Use the 2
M5x12 screws and the 2 washers and screw the base plate to the
machine. For wall thicknesses greater than 6 mm, replace the
screws with longer ones.
6.3
Attachment of the meter
Hook the counter with the 2 slots into the notches at
the top of the mounting plate and place it on the base
plate.
Now you should check whether the counter counts as
desired in the selected position when operating your
machine. If not, you will need to look for a more
suitable mounting position.
ATTENTION: The meter is not secured yet - risk of loss!
6.4
Securing the meter
If the counter works perfectly at the position you have
selected, it will be fixed with the securing element.
Press the securing element from bottom to top into the slot
of the housing until it clicks into place.
ATTENTION: The meter can not be removed anymore.
If you want to use the meter on more than one machine, you
must install the meter on an additional plate that you can
change.