7
screw.
DIE REPLACEMENT
The punch in its raised position, loosen the two
screws and replace the die.
SWITCHING THE MACHINE ON AND
OFF
To switch on:
While holding with the left hand on the front grip
and the right hand on the main handle, slide the
switch slider forward until it locks in the "on"
position.
To switch off:
Push down on the back of the switch slider, which
will release the lock and switch the machine off.
Die Holder
Die
Punch
Piston
Set Screw
screw
slider switch
HOW TO USE THE TOOL
Effective control of this machine requires
two-
handed
operation for maximum safety and
control.
The proper hold is to keep one hand on the main
handle and the other hand on the grip . It is vitally
important to keep stable footing at all times,
OPERATIONS
Once the machine is set up and all safety
measures and equipment are in place, begin by
turning on the machine.
Begin working and contact the workpiece. It is
not necessary to use excessive down force. Allow
the machine to work at the pace it was intended.
MAINTENANCE
Every 50 hours of operation blow compressed
air through the motor while running at no load
to clean out accumulated dust. (If operating in
especially dusty conditions, perform this operation
more often.)
KEEP TOOL CLEAN
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to
clean plastic parts. They could possibly dissolve or
otherwise damage the material.
Wear safety glasses while using compressed air.
