AGP HS225, Оригинальное руководство пользователя

Страница: 6 / 20

6
Safety Warnings for Sanding Operations:
1. This power tool is intended to function as a sander. Read all safety warnings, instructions,
illustrations and specifications provided with this power tool. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury.
2. Operations such as grinding, wire brushing, polishing or cutting-off are not recommended
to be performed with this power tool. Operations for which the power tool was not
designed may create a hazard and cause personal injury.
3. Do not use accessories which are not specifically designed and recommended by the tool
manufacturer. Just because the accessory can be attached to your power tool, it does
not assure safe operation.
4. The rated speed of the accessory must be at least equal to the maximum speed
5. marked on the power tool. Accessories running faster than their rated speed can break
and fly apart.
6. The outside diameter and the thickness of your accessory must be within the
7. capacity rating of your power tool. Incorrectly sized accessories cannot be adequately
guarded or controlled.
8. The arbor size of wheels, flanges, backing pads or any other accessory must properly
fit the spindle of the power tool. Accessories with arbour holes that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively and may
cause loss of control.
9. Do not use a damaged accessory. Before each use inspect the accessory such as
backing pad for cracks, tears or excess wear, If power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After inspecting and installing an
accessory, position yourself and bystanders away from the plane of the rotating accessory
and run the power tool at maximum no-load speed for one minute. Damaged accessories
will normally break apart during this test time.
10. Wear personal protective equipment. Depending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and
workshop apron capable of stopping small abrasive or workpiece fragments. The eye
protection must be capable of stopping flying debris generated by various operations. The
dust mask or respirator must be capable of filtrating particles generated by your operation.
Prolonged exposure to high intensity noise may cause hearing loss.
11. Keep bystanders a safe distance away from work area. Anyone entering the work area
must wear personal protective equipment. Fragments of workpiece or of a broken
accessory may fly away and cause injury beyond immediate area of operation.
12. Position the cord clear of the spinning accessory. If you lose control, the cord may be cut
or snagged and your hand or arm may be pulled into the spinning accessory.
13. Never lay the power tool down until the accessory has come to a complete stop. The
spinning accessory may grab the surface and pull the power tool out of your control.
14. Do not run the power tool while carrying it at your side. Accidental contact with the
spinning accessory could snag your clothing, pulling the accessory into your body.
15. Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the
housing and excessive accumulation of powdered metal may cause electrical hazards.