AGP EV10ELM, Оригинальное руководство пользователя, Страница: 7 / 12

7
Starting Operation and Use
Check if the data on the nameplate is corresponding with the actual mains voltage.
Improper use may damage the Instrument. Observe therefore these Instructions:
•
Use just mixing paddles up to the specified diameter.
•
Load the instrument in such a way that the speed would not drop considerably or that it
would stop.
Fixing a Mixing-Paddle:
Screw the mixing-paddle (41) with thread M 14 x 2 as far as possible in the spindle hole and
tighten properly with an open-end wrench (40), which is included.
Switching On and Off:
By pressing the switch button (34) the machine is brought into operation and it stops when this
is relieved.
Permanent Run:
By pressing the switch button (34) the stop and simultaneous pressing the arresting pin
permanent run is achieved. By subsequent pressing and relieving of the switch button the
permanent run is interrupted.
Unloading the Mixing-Paddle:
Fit a flat open-end wrench (40) on the spindle flats (01) of the tool and unscrew the mixing-
paddle (41) from the spindle by turning it to the left.
Maintenance
•
This power tool normally requires no maintenance; from time the ventilation holes on the