AGP CS320, Оригинальное руководство пользователя

Страница: 14 / 20

14
CAUTION: Failure to use a backing workpiece on the first cut may result in the rubber strip being torn
or damaged by the blade
Once it is cut to size, it will perfectly correspond to the cutting edge and will also help to protect the material
from splintering. Once it is sized, the operator can know at a glance exactly where the line of cut will be. This
saves a lot of time and effort in making precise cuts.
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft
damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the
material.
Wear safety glasses while using compressed air.
Clean all parts of the lower blade guard mechanism to ensure smooth operation.
MAINTENANCE
The carbon brushes:
The carbon brushes are a normal wearing part and must be
replaced when they reach their wear limit. See fig.11
Caution: Always replace the brushes as a pair
To replace:
1.
Remove the brush caps and withdraw the
old brushes. See fig.12
2.
Replace with new brushes (always replace as a pair)
ensuring that they align properly and slide freely.
Installation is the reverse of removal.
3.
Then replace the brush caps.
STANDARD ACCESSORIES
6mm L- hex key
If the replacement of the power supply cord is necessary, this has to be done by the manufacturer or
their agent in order to avoid a safety hazard
Fig.11
Brush Cap
Fig.12