AGP CS200, Оригинальное руководство пользователя

Страница: 10 / 20

10
HOW TO USE THE SIGHTING NOTCH
To aid in free-hand cutting, a sighting notch is located at the front
of the base (15). See fig. 6 Align the cutting line on the workpiece
with the sighting notch. Make the cut. Use the right-hand notch
(between the two marking dots) for straight cuts and the left-
hand notch (located below the rivet) for 45 degree bevel cuts.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the same as that
shown on the specification plate of the machine and that switch
is “OFF” before connecting the tool to the power circuit. To start
the machine, first press the safety lock button then squeeze the
trigger switch to start the motor. Release the trigger switch to
stop the motor. See fig.7
REMOVING CHIPS
This dry-cut metal saw has an internal chip collector. When the chip collector is full, the chips must be cleared.
To do this, first shut down and DISCONNECT TOOL FROM POWER SOURCE.
The outer blade cover lock knob (25) has a bayonet lock thread. See fig.8 To remove cover(28), turn knob
anticlockwise while pushing in against the spring tension. Then
lift cover away. Recently-cut chips can be very hot. Take care when
removing the cover to keep the chips or shavings away from your
hands or other body parts. Do not throw hot debris where paper
or other flammable materials are located. To replace the outer
blade cover, line up tang with slot and push in against the spring
while turning clockwise. Ensure that the cover is properly seated.
HOW TO USE THE RIP FENCE
Using the rip fence (24) will provide more accurate straight cuts
than by cutting free-hand. For installation, DISCONNECT TOOL
FROM POWER SOURCE then insert the rip fence in the mounting
slots. In the base (15). See fig.9 Select the desired cut width on
the cutting guide and tighten the 2 thumb screws(16) to lock.
LOWER RETRACTING BLADE GUARD
The lower retracting blade guard (6) is a safety device important for your protection. Every time you use the
saw, make sure that the guard rotates freely and returns quickly and completely to its closed position. Before
each use, remove any accumulated chips, or shavings from the area around the hub of the guard. DO NOT
LUBRICATE THIS AREA. The hub has a dry film lubricated surface that does not need oiling. NEVER block or
wedge the blade guard in the open position. NEVER use your saw if the blade guard is not in working order.
Sighting notch
Straight cut
notch
45 Degree
bevel notch
Fig.6
Safety lock button
Trigger switch
Fig.7
Cover lock knob
Fig.8
Rip fence
Fig.9