AGM JS-1, Инструкция по эксплуатации

Страница: 28 / 38

28
ALTERNATE GUN SET-UP FOR STUDS OVER 1-3/8” LONG
GUN SET-UP WITH HEAVY 3” SPRING & 2318-M FOOT PIECE ASSEMBLY
A. Install proper stop (1), collet (2) and protector (3). Make sure the collet holding
set screws are tightened securely. See the chart below and on previous page for
part numbers.
B. If previously installed, remove the 1151-M legs from the faceplate.
C. Insert adjustable legs (9) of foot assembly into the holes provided on the
faceplate.
D. Insert the proper spark shield (5) into the foot piece (8) and tighten the set screws
(4).
E. Insert the stud through the spark shield, protector and into the collet, until stud
rests against the stop.
F. Check for freedom of movement between the spark shield and the stud. If they
bind, loosen the two cap screws (6) and move the foot piece until the stud is
centered in the spark shield. Once done, tighten the cap screws securely.
G. Adjust the foot piece by loosening the two set screws (10) and sliding the
assembly as required. The stud should extend beyond the spark shield
approximately
¼”
as shown. Once done, tighten the set screws securely.
The gun is now ready for welding.
Items 6, 7, 8 & 9 are part of 2318-M Foot Piece
NOTE - See spring set up for ¼” threaded studs page 27.