AGM Global Vision RATTLER TS35-640, Руководство пользователя

Страница: 14 / 32

AGM Global Vision 14
2.1.16 INSTALLING THE RATTLER ON A PICATINNY/WEAVER RAIL
WARNING:
Always make sure your firearm is unloaded before you place the scope on the
firearm. Reconfirm that the chamber is empty if you stop the procedure then
resume later. Safe firearms handling rules should be followed at all times.
The Rattler comes fully-assembled with a Picatinny/Weaver mount. The mount
is attached to the scope with two screws.
To install the Rattler on a Picatinny/Weaver rail, perform the following
(Figure 2-5):
1. Unlock the clamping device of the scope mount by pushing down on the lever
holder (A) and unlocking the lever (B).
2. Install the scope on the Picatinny/ Weaver rail so that the stop (C) slides into
the transverse slot on the rail.
3. Affix the scope to the rail by locking the lever (B).
4. Verify that the clamping device is firmly holding the Rattler. If necessary,
adjust the clamping device’s lever-cam lock as detailed in part 2.1.17
(Clamping Device Adjustment).
2.1.17 CLAMPING DEVICE ADJUSTMENT
To adjust the mount’s clamping device, do the following:
1. Remove the Rattler from the weapon.
2. With the clamping device unlocked (as shown in Figure 2-5), push the cam
(E) towards the arrow, which will cause the nut (D) to slide out of its hole.
3. To tighten/ loosen the clamping device, push down on the cam (E) and turn
the nut (D) CW/ CCW respectively, in one-two increments (see note below).
Much like when the cam (E) is released, backward-moving spring will cause
the nut (D) to slide back into its hole.
NOTE:
The eight-sided nut of the mount lever-cam lock will only fit into their hole if
XYVRIHMRSRISJXLIHMWGVIXITSWMXMSRWYWMRKMRGVIQIRXWIUYEPXSq
4. Verify that the adjusted lever-cam lock securely holds the weapon mounting
rail.
FIGURE 2-5. MOUNT
03'/)('0%14-2+
DEVICES
9203'/)(
CLAMPING DEVICE
92()67-():-);
UNLOCK
TURN
PUSH
B
B
A
A
C
E
D