9
2 Sek
.
+
2 Sec
.
Tilt Function in grade mode
If the laser while working with grades is tilted or disturbed the laser will
stop and in the display the failure symbol will flash.
By pressing the X/Y and rotation button for 2 seconds at the
instrument or the remote control the levelling will be done again
and the laser will again start to work. In this case please check the
correct position of the laser instrument at you original bench mark.
When the laser is working in horizontal mode without grades and the
tilt alarm is active, it has to be turned off and on again.
Rotation speed
The laser speed can be changed from 0 RPM, 600RPM to 800RPM.
This offers a stable signal for a machine control systems. To work with
a laser spot, press gain the rotation button. The laser spot then can be
moved with the arrow keys.
Mask mode
In the mask mode the laser beam can be switched off in different
sections. This function is used to avoid interference with different laser.
It also avoids glare when in use e.g. at a motorway.
To turn on the mask function, press the mask button. The laser beam is
masked in a range of 90°. By pressing again the button it changes to
180° and then to 270°.
With the arrow buttons the masked sector can be changed to the
needed direction. In the scan mode and laser spot mode the mask function is
deactivated.
To turn off the mask mode, the laser has to be switched off.
Scan Mode
In the scan mode the laser beam projects a line. This has an advantage
when working interior as there is no receiver necessary. The line can be
moved with the arrow keys. Pressing the button gain will increase the
laser line length. To switch back to rotation press the rotation button..
