Agilent Technologies TS-5410, Руководство по подготовке места и установке

Страница: 26 / 30

26 Test System Installation Chapter 2
2. Connect the monitor’s power cord to the receptacle on the Filtered
Power Strip located in the bottom rear of the rack (Figure 2-6).
Note
The monitor receptacle is rated for 2 Amp maximum current.
3. Use cable tie wraps to secure the cables to the Cable Strain Relief
Blocks. After securing all cables, you can apply power to the system
by setting the front panel on off switch to ON.
Note
DO NOT secure the AC power cord to the cable strain relief bracket such
that it would prevent the plug from being removed from the power strip in
an emergency.
Figure 2-5. PC and GPIB Connector Panel
COM 1
COM 2
USB USB LAN
MONITOR
KEYBOARD MOUSE
GPIB
Hole for
Routing Wires
External GPIB
Connector
COM 1,
Not Used
USB LAN USB Monitor Keyboard Mouse
Cable Strain
Relief Block
Cable Strain
Relief Block
Figure 2-6. Monitor Power Connector
REAR
AC Power
Connect Monitor
Power Cord Here
Cable Strain
Relief Blocks
AC Power Cord