Agilent Technologies HP 83711A, Руководство пользователя

Страница: 208 / 251

Error Messages
Messages
A data lookup from the factory level correction oset table found
that the index data is out of range . Try setting the same synthesizer
function again. If this error message persists , run the instrument self
test.
763 763,"Unable to write to EEPROM;(763)"
A calibration table was not loaded into EEPROM because the EEPROM
was protected or the EEPROM load did not verify . Open up the
synthesizer and switch the PG switch to 0.
764 764,"Unable to write to RAM;(764)"
A write to RAM failed to verify . Run the self test routine to check RAM
for problems .
765 765,"Attempt to write to ROM;(765)"
There was an attempt to write calibration data to ROM. This should
not occur , but if it does , try setting the same synthesizer function
again. If this error message persists , run the instrument self test.
766 766,"Number of writes to EEPROM exceeds max;(766)"
The number of EEPROM writes has exceeded the maximum allowed.
However , the data was written to the EEPROM anyway . This is only a
warning; but, you should check to make sure your data was correctly
stored in EEPROM.
770 770,"YTO cal data invalid;(770)"
The YIG oscillator factory calibration data checksum was incorrect.
Select the CAL YIG OSC feature to perform a YIG oscillator calibration.
If you do not re-calibrate , the synthesizer may be unable to attain lock
at some frequencies .
771 771,"Invalid YIG D A C value in cal table .;(771)"
The YIG oscillator factory calibration data checksum was incorrect.
Select the CAL YIG OSC feature to perform a YIG oscillator calibration.
If you do not re-calibrate , the synthesizer may be unable to attain lock
at some frequencies .
772 772,"YTO cal values for Up/Down search vary;(772)"
The YIG oscillator factory calibration data checksum was incorrect.
Select the CAL YIG OSC feature to perform a YIG oscillator calibration.
8-20