Agilent Technologies E8356-60104, Установочная инструкция, Страница: 12 / 19

12 Installation Note E8356-90052
Reinstall the Inner and Outer Covers
Refer to Figure 5 for this procedure.
Reinstall the Inner Cover
1. Place the inner cover on the analyzer. There are two alignment pins on the front frame
that must be aligned with holes in the cover.
2. With a T-10 TORX driver, install the 15 screws (item
①
).
Reinstall the Outer Cover
CAUTION
This procedure is best performed with the analyzer resting on its front handles
in the vertical position. Do not place the analyzer on its front panel without the
handles. This will damage the front panel assemblies.
1. Slide the cover onto the frame.
2. With a T-20 TORX driver, install the four rear panel feet (item
②
) by installing the center
screws (item
③
).
3. Slide the four bottom feet (item
④
) onto the cover.
4. With a T-20 TORX driver, install the strap handles (item
⑤
) by tightening the screws
(item
⑥
) on both ends.