Installation Note E4400-90392
9
2. Set GPIB parameters as follows on ESG-B family signal generators:
a. Press
Utility
>
GPIB/RS-232
>
GPIB Address
>
19
.
b. Use the numeric keypad, the arrow keys, or rotate the front panel knob to set the
desired address and press Enter.
The signal generator’s GPIB address is set to 19 at the factory. The acceptable range of
addresses is 0 through 30. Once initialized, the state of the GPIB address is not affected
by a signal generator preset or by a power cycle. Other instruments on the GPIB cannot
use the same address as the signal generator.