Agilent Technologies 85103F, Руководство по установке

Страница: 34 / 35

24 85103F Performance Upgrade Installation Manual
The 85103F Upgrade Package (8510A/B to 8510C)
Checking the 8510C
Time Domain Option Functional Check
If the 8510A/B was equipped with the time domain option (Option 010), either originally or
through an upgrade, then the 85103F upgrade package ordered should also have been
equipped with Option 010. If so, there should be a serial number label on the back of the
85101C with OPT: 010 printed on it.
The time domain option firmware is included in both the LCD and CRT 8510C operating
system versions. It is enabled by the time domain option security key IC inside the 85101C.
Refer to the On-Site Service Manual for the location of this IC.
Use this procedure to verify that the time domain option has been installed properly.
1. Turn on the instruments in the following order:
a. Source (make sure that the switch is turned to power on and not standby)
b. Test set
c. 85102 IF/detector
d. 85101 display/processor
2. On the 85101:
a. Press
INSTRUMENT STATE RECALL
and
[MORE], [FACTORY PRESET]
.
b. Press
DOMAIN
and select
[TIME LOW PASS]
.
Does the instrument display the Set Frequency (low pass) menu? If so, the time
domain option is installed properly. If not, recheck the installation of the IC.