Agilent Technologies 5DX II Series, Руководство по установке

Страница: 32 / 87

Installation - 18
Figure 8 Cable Harness Routing
ELECTRONICS BAY
There are two cable harnesses or
bundles that route to/from the
electronics bay. It is easiest to do
the wiring with the rear door,
access panel and sides removed.
!
!
!
The cable bundle from the main unit
is routed through the larger hole in
the bottom panel. The bundle
containing the monitor, keyboard,
etc. cables goes out the smaller
hole.
Each hole has a removable cable
clamp to make cable routing easier.
It is best to remove the whole panel
to route the cables initially.
Cables from the main unit and from
the electronics bay are labeled. The
labels indicate where each cable
should be routed. Cables from the
main unit show which connection is
to be made at the electronics bay.
Cables from the electronics bay are
labeled for their routing to the
workstation table.
Keyboard, mouse,
monitor, etc. cables
come out here.
Cables from the main
unit are routed into here.
AC Main (installed by the
Customer’s electrician)
Power to the mobile workstation
out here.
table and the main cabinet come