AGI GRAINMAXX 6300 Series, Руководство оператора

Страница: 40 / 60

40 8210-00023 R0
Section 7.8 – Check Upper and Lower Gearbox Oil Levels on page 48
Annually:
Section 7.4 – Lubricate the Equipment on page 41
Section 7.7 – Oil and Adjust the Chain Drives on page 46
Section 7.10 – Clean and Wash the Equipment on page 49
2–3 Years:
Section 7.9 – Change the Gearbox Oil on page 48
Section 7.7 – Oil and Adjust the Chain Drives on page 46
Section 7.6 – Inspect and Service the Hydraulic Winch and Lift Cable on page 45
As Required:
Section 7.11 – Repack the Wheel Bearings with Grease on page 49
Section 7.13 – Replace the Shear Pin on page 51
Section 7.12 – Check/Adjust the Truss Cables on page 50
7.3. Visually Inspect the Equipment
Lock out power before inspecting.
Check the following during a visual inspection:
1. Ensure all guards are in place and in good working order.
2. Examine the auger for damage or unusual wear.
3. Check tightness of bolts/nuts, fasteners, and hardware (re-torque if necessary).
4. Be sure all safety decals are in place and are legible.
5. Check that the discharge and intake area are free of obstructions.
6. Inspect all moving or rotating parts to see if anything has become entangled in them. Remove any entangled
material.
7. Inspect hydraulic hoses and fittings for leaks and wear. Fix or replace where necessary.
8. Check wheel bolts are tight and examine tires for gashes, uneven wear, or loss of air pressure. See Section 9.
– Specifications on page 56 for recommended tire pressure and torque information.
9. Check all operating, lifting, and transport components. Replace damaged or worn parts before using the
auger.
10. Inspect the auger shaft bushing for unusual wear or discoloration.
11. Check the PTO shield & replace if damaged.
12. Inspect the truss cables for proper tension and possible damage such as fraying, kinking, or unwinding.
13. Inspect the winch cable for fraying, kinking, unwinding, or other possible damage.
7. MAINTENANCE 6300 SERIES – PORTABLE GRAIN AUGER