AGI AKEHO TS-805 Series, Инструкция по установке, эксплуатации и ремонту

Страница: 11 / 88

CNA-1815 R5 11
2.6. Electric Motor Safety
Power Source
• Electric motors and controls shall be installed and serviced by
a qualified electrician and must meet all local codes and
standards.
• Do not modify the magnetic starter. This component provides
overload and under-voltage protection.
• Motor starting controls must be located so that the operator
has full view of the entire operation.
• Locate main power disconnect switch within reach from
ground level to permit ready access in case of an emergency.
• Motor must be grounded.
• Guards must be in place and secure at all times.
• Ensure electrical wiring and cords remain in good condition;
replace if necessary.
S E R V I C E D I S C O N N E C T
ON
OFF
Lockout
• The main power disconnect switch should be in the locked position during shutdown or
whenever maintenance is performed.
• In the event of unexpected fan shutdown, the fan can be reset using the main power switch
located on the fan or using a reset button when equipped.
2.7. Personal Protective Equipment
The following Personal Protective Equipment (PPE) should be worn when operating or maintaining the
equipment.
Work Gloves
• Wear work gloves to protect your hands from sharp and rough edges.
2.8. Safety Equipment
The following safety equipment should be kept on site:
Fire Extinguisher
• Provide a fire extinguisher for use in case of an accident. Store in a highly visible and
accessible place.
AERATION FAN – SUPER-FLOW FULL CENTRIFUGAL FAN 2. SAFETY