AGI A383, Инструкция по сборке

Страница: 23 / 34

31020 R1 23
4.3. Assemble Auger Components
During the assembly of the auger, the following standard parts must be replaced by parts modified to be
compatible with the X-Tend Hopper:
• hopper lift arm (installed with hydraulic winch), see Section 4.3.1 – Install the X-Tend Hopper Lift Arm on
page 23
• intake-end single cross brace, see Section 4.3.2 – Replace the Short Truss Brace — For 84', 94', and 114'
Models on page 24
• PTO/valve bracket, see Section 4.3.4 – Replace the PTO/Valve Bracket on page 27
4.3.1 Install the X-Tend Hopper Lift Arm
For retrofits, during the assembly of the auger, ensure that the standard lift arm is replaced by the X-Tend
Hopper lift arm.
1. Attach the lift arm mount to the lift arm mount brackets using six 1/2” x 1-1/2” bolts and locknuts.
2. Position the hopper lift arm assembly on the X-Tend hopper lift arm mount with the arm overhanging the
side of the auger that the hopper will be operating on.
3. Fasten the hopper lift arm assembly to the mount bracket using five 1/2” x 1-1/2” bolts and locknuts.
Figure 5. X-Tend Hopper Lift Arm
1
3
4
2
3
4
2
1
Hopper Lift Arm Assembly
3
Bolt, 1/2" x 1-1/2"
2
MKX13/X13/HX13 Lift Arm Mount
4
Locknut, 1/2"
A383 X-TEND HOPPER 4. ASSEMBLY