INSTALLATION
Step1: Find the supplied installation sticker, and paste it to where you want to install.
Then, screw holes as marked on the sticker for installation later.
Step2: Loosen the screw as indicated below to move down the camera lens.
Then, fasten the camera to the ceiling or wall.
Step3: Adjust the viewing angle of the camera as indicated below.
Step4: Slide the sun shield to the camera, and fasten it with the supplied screw.
Step5: Power on the camera and fine-tune the viewing angle.
CONNECTION
1. DC12V
Input
Terminal
Connect the power terminal of the camera to a DC 12V regulated power supply.
NOTE:
Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power
tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this
unit.
2. Video Output Connector (VIDEO OUT)
Connect the camera video output to the video input of a DVR with 75
Ω
coaxial cable.
NOTE:
To ensure the camera has sufficient protection against moisture, an extra waterproof
measure, such as by using an insulating tape, must be used to cover the power and video
connectors after connection.
