AGFA DuoScan, Руководство пользователя

Страница: 21 / 41

Chapter 2 — Installing the scanner 21
■
For the PC:
■
A 486 processor.
■
A 13 inch color monitor (24 bit color display recommended).
■
16 MB of RAM.
■
A high-capacity disk drive.
■
A SCSI (Small Computer System Interface) interface card supported by FotoLook for
connecting your scanner. In general, FotoLook supports all fully WINASPI compatible
cards. Some SCSI cards require a special SCSI cable. Contact your supplier for the proper
cable. A regular SCSI cable is included in the packaging.
You should review your PC's documentation with respect to installing SCSI interface
cards. Check the installation and setup guidelines in the documentation that is supplied
together with your SCSI interface card.
■
The amount of disk space available on your PC determines the number and size of the
images you can scan. Make sure you have enough free storage space on your hard disk.
You need about two times the size of the image to scan, edit and save an image. You
need a minimum of 30 MB free hard disk space and 8 MB of RAM for color images.
■
An IBM PC or compatible capable of running MS Windows, Windows 95 or Windows NT.
Environmental requirements
■
Place the scanner on a horizontal, flat surface.
■
To ensure proper ventilation, allow a minimum of 10 cm (4 inches) free space around each side
of the scanner and a minimum of 15 cm (6 inches) at the rear of the scanner.
■
Make sure that no vibrations or shocks occur.
■
Make sure that the area is free of excessive dust.
■
Avoid any contact with water.
■
The scanner is designed to operate optimally when the environmental temperature is between
10 °C and 40 °C. Avoid exposure to direct sunlight and heating devices.
■
The scanner is designed to operate optimally when the environmental humidity is between
10 % and 85 %. Avoid environments where humidity fluctuations might occur.
■
Check whether the voltage of the power cable corresponds to the voltage in your area. If not,
contact your dealer or Agfa service representative.