AGCO Glencoe SS7400 Soil Saver, Руководство по сборке

Страница: 11 / 51

ALL MODELS
1. Mount both left and right mounting channel
assemblies to main frame with 3/4" x 3-1/2" bolts
and locknuts.
2. Position pivot shaft with spring lugs to rear into
mounting channels and on top of bearing mount
on tongue. Secure to mounting channels and
bearing mount with bearings, 3/4" x 1-3/4" bolts
and locknuts. Do not tighten hardware. Mount
reflector bracket.
3. Position gang so gang bolt nut is toward outside
of right slicer gang. Assemble upper and lower
bearing, spacer, U-bolt and locknuts to center
bearing support. Do not tighten. Slide right
slicer gang under machine into bearing
assembly with slicer blades to front.
4. Fasten remaining end of slicer gang to channel
by placing an upper and lower bearing on gang
tube. Clamp bearings to channel with U-bolt,
lock washers and nuts.
5. Repeat for left slicer gang. Tighten all bolts.
6. Hook ears of pressure rod to hole in rear of bar
on gang frame. Secure with clevis pin and cotter
pin.
7. Attach center scraper under tongue and directly
behind bearing mount with U-bolt and locknuts.
8. Attach the turnbuckle between anchor on main
frame and anchor on pivot shaft.
Note: An optional hydraulic cylinder is available.
IMPORTANT! Tighten all bolts to proper torque.
11
MAIN FRAME SLICER