AGA FFD, Руководство по установке

Страница: 10 / 16

11. Complete the main cooker build and loosely screw down the top plate.
12. (a) Remove Gas Hob from box.
(b) Disconnect electrical supply cable from hob chassis.
(Unscrew wires from terminal strip and slacken screw in cable clamp).
(c) Feed electrical cable supply in through appropriate grommets in hotcupboard.
(Ensuring cable does not become tangled).
13. Apply tape (supplied) to the underside of the lap strip in the hotcupboard top plate. Loosely
place hotcupboard top plate into position on hotcupboard.
14. Place the hob chassis near the cut-out in the top plate casting. Feed the electrical supply
cable in through the cable clamp. Re-connect wires to terminal strip as wiring diagram,
and tighten screw on cable clamp.
14A. Fit 4 push on clips (supplied with hob unit) on to the slots in top plate (See Fig. 10).
15. Lower the rear face of the chassis into the cut-out in the casting. Slide backwards,
ensuring that the supply pipe lines up with, and makes adequate contact with the
compression fitting on the gas cock.
16. Fix the chassis in position using the four (M5 size) screws (supplied with hob unit). (See
Fig. 10).
17. Make final gas connection to the gas cock on the hob unit (8mm compression). (See Fig.
11.). After connecting the gas supply turn the gas cock to the
ON position, check for gas
tightness.
Fig. 10
Fig. 11
DESN 513599
DESN 513601
10