Check contents against checklist.
Follow instructions carefully. When using power tools always follow the manufacturers safety
requirements.
STEP 1
Remove the hotcupboard top plate.
STEP 2
Decide whether the mains is to enter from the back or side of the hotcupboard.
Drill appropriate holes and fit grommets.
STEP 3
Clamp hob unit into top plate using the two clamping brackets and ensuring seal is
correctly positioned. Turn each tension screw until it makes contact with the top plate.
Using a screwdriver further tighten a maximum of one and a half turns. This should
be sufficient to compress the seal. Do not overtighten.
6
FITTING YOUR HOB INTO AN EXISTING AGA
DESN 511717
DESN 511718
25mm
65mm
A
A
B
B
100mm
25mm
65mm
100mm
340mm
240mm
REAR
SIDE
NOTE
1. REAR ENTRY - HOLES A
2. SIDE ENTRY - HOLES B
3. ALL HOLES 19mm
DIAMETER
4. GROMMETS INSERTED
INTO INNER & OUTER
PANELS
CABLE ENTRY
