WARNING: THIS APPLIANCE MUST BE EARTHED.
Any adjacent walls that project above the height of the hob must be of heat resistant material.
The side and back wall above the hob shall be greater than 60mm from the cooker.
Surfaces over the top of the cooker must not be closer than 650mm.
THE ISOLATOR SHOULD
NOT
BE POSITIONED IMMEDIATELY ABOVE BOTH THE HOB OR
THE MAIN COOKER, BUT
MUST
BE SITED WITHIN 2 METRES OF THE APPLIANCE.
The hob must be wired and installed by a Qualified Engineer in accordance with the Current
National Wiring Regulations and also any local regulations which apply.
The appliance requires a 13 amp, 230 Volt - 50Hz supply.
The method of connection to the mains supply should facilitate complete electrical isolation of
the appliance, by the use of a fused double pole switch having a contact separator of at least
3mm serving only the appliance. The point of connection should be accessible and adjacent to
the appliance. The installation should be protected by a 30 mA Residual Current Circuit Breaker
(RCCB).
IMPORTANT
The wires in the mains lead on this appliance are coloured in accordance with the following:-
Green/Yellow - Earth
Blue - Neutral
Brown - Live
COOKER CONTENTS CHECKLIST
AGA PART No.
DESCRIPTION
QUANTITY
Hob unit c/w knobs and 3m silicon cable
1
AE4M240198
Data Plaque
1
Fixing Brackets
2
Screw M4 x 50 Pan Hd Pozi Z/P
4
Screw M4 x 25 Pan Hd Pozi Z/P
4
AG2M210711
Baffle Plate
1
KPAN52551
Screw No.8 x 3/8” Pan Hd Pozi Z/P S/T
2
JPAD210722
Insulation Pad
2
AG4M210766
Grommet - PV73M
2
Seal
1
EINS511674
Installation Instructions
1
EOPI511675
Users Instructions
1
Carton
1
AE4M240205
3 pin plug with 13 amp fuse
1
4
GENERAL REQUIREMENTS
