13
OVERLAY DOOR PANEL INSTALLATION
Overlay panel
flush with top
and side of
door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 14 to 21. The window cut out
is for glass door models only. If your appliance has a lock
also drill the lock hole in the panel, see Figure 22.
Overlay panel to
be centered on
width of door.
Figure 13
Holes in
gasket
retainer.
Figure 12
Press and hold this down
this tab on the wire connec-
tor and pull the connector
apart.
Figure 13a
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 13. Set the gasket
aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack along with the door lock,
which is provided on certain models.
Loosen (do not remove ) these
2 phillips head screws on the
top and bottom hinges
!
WARNING
Use extreme caution with the articulated hinges. The
hinge is self closing and many pinch points exist prior
to built-in installation.
Do not remove the cabinet "Z"
bracket from the top of the cabinet.
Figure 11b
Bottom of
door
"P" clamp
and screw
Wire connector
see Figure 12
Figure 11
Figure 11a
Cabinet
"Z" Bracket
