AGA marvel ML15WSF3 Series, Инструкции по установке, эксплуатации и обслуживанию

Страница: 28 / 93

28
• Replace all parts and panels before operating.
In the unlikely event you lose cooling in your unit, do not
unplug the product from the electric supply , but do call
a qualified service technician immediately. It is possible
that the loss of cooling capacity is a result of excessive
frost build-up on the evaporator cooling coil. In this case,
removing power to the unit will result in the melting of this
excessive quantity of ice, which could generate melt water
that exceeds the capacity of the defrost drain system and
could result in water damage to your home. The end-user
will be ultimately responsible for any water damage caused
by prematurely turning the unit off without appropriately
managing the excess water run-off.
Problem Possible Cause Remedy
Appliance not cold enough
(See “Adjusting the temperature" on
page 10)
•
•
Control set too warm
Content temperature not
stabilized.
• Adjust temperature colder. Allow
24 hours for temperature to
stabilize.
•
Excessive usage or prolonged
door openings.
• Allow temperature to stabilize for
at least 24 hours.
•
Airflow to front grille blocked.
• Airflow must not be obstructed to
front grille. See “clearances” on
page 4.
•
Door gasket not sealing properly.
•
Replace door gasket.
Appliance too cold
(See “Adjusting the Temperature” on
page 10)
•
Control set too cold
•
Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.
•
Door gasket not sealing properly.
•
Replace door gasket.
No interior light.
•
Failed LED light assembly or light
switch.
• Contact a qualified service
technician.
Light will not go out when door is
closed
•
Display light is turned on. (Glass
door models only.
•
Turn off display light, shut door.
•
Door not activating light switch.
• Appliance not level, level
appli
ance, (See page 4, “leveling
legs”)
•
Failed light switch
• Contact a qualified service
technician.
Noise or Vibration
•
Appliance not level
• Level appliance, see “Leveling
Legs” on page 4.
•
Fan hitting tube obstruction.
• Contact a qualified service
technician.
Appliance will not run.
•
Appliance turned off
• Turn appliance on. See “Starting
your appliance” on page 10.
•
Power cord not plugged in.
•
Plug in power cord.
•
No power at outlet.
•
Check house circuit.
!
CAUTION