AGA marvel M48C2TF, Инструкции по установке, эксплуатации и обслуживанию

Страница: 25 / 72

25
CUSTOM GRILLE FACIA AND DOOR PANELS
!
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move product.
Failure to do so can result in back or other injury.
Support
door before
removing
hinge-
Step #1: Remove the Door
Support the door at the floor.
1. Loosen the set screw in the bullit cap with a
3
⁄
32
" hex
key and remove the bullit cap from the hinge pin by
sliding off. Do this to both the top hinge and at the bot-
tom hinge. Set aside parts for later reassembly.
2. Loosen
5
⁄
16
" Hex Nut underneath the hinge with a
1
⁄
2
"
open end wrench, unscrew completely from the hinge
pin.
3. Make sure the door is supported, and remove the hinge
pin from the cabinet hinge with a flat bladed screw -
driver.
4. Carefully lift the door off the lower hinge.
5. Assemble parts in reverse order.
Figure 26
Bullit cap-
-Set screw
-
5
⁄
16
Hex
nut
Top hinge
pin-
Door
hinge-
-Cabinet
hinge
Figure 27
Custom Door Panel Installation Instructions
Determine Wood Screw Requirements
1. A #10 pan head wood screw should be used to prop -
erly secure the overlay panel. Screws are supplied with
unit.
2. Use only pan head screws.
3. If your overlay panel is thinner than
5
⁄
8
" (15.9 mm)
you will need to purchase shorter screws. The longer
screws will break through the front of the panel.
-Bullit cap
Set screw-
-Door
hinge
-Cabinet
hinge
Figure 28