Ag-Tester HT101S, Справочное руководство

Страница: 8 / 12

8
Battery Care-
HT101V and HT101S Testers
These testers are equipped with a high power, 12 volt 1000 MAH Nickel- Cadmium “NI-
Cad” battery. The testers will run about 10 hours constant without a re-charge. Re-
Charge takes about 4 hours.
The battery level can easily be checked using the voltmeter built into the tester.
Turn the tester ON, set to VOLTS, and Connected Point
to BATT CHECK. The current voltage will be
displayed.
After a full charge, it may read in excess is 13 volts, then will stabilize at about 12.2 to
12.8 volts.
Ni-CAD batteries develop a memory over time. If they are recharged after each short
usage, they will develop that memory and at some point only deliver that capacity. MAXIMUM battery life with the
strongest usage cycle is achieved by charging the battery when the voltage drops below 12.0 volts. Check the voltage as
your putting away the tester. If the voltage is 12.0 volts or less, recharge.
Use only the SMART CHARGER that came with the tester. The charger will turn
itself off when the battery is charged so there is no chance of
overcharging.
The charge indicator light turns RED when charging and when fully charged the
light turns green.
Batteries are replaced at Ag-Tester. Go to agtester.com for details.