61
ADJUSTING THE LCD DISPLAY
Item
Function
Operation
Range
Switch on delay
Adjust the power-on delaying time
(in seconds) allows a sequential
powering-on for each display by
their ID number when multiple
displays are connected.
Press the / button on the
control panel or the / button on the
remote control to adjust the value.
0 to 60
Logo
When enabled, the AG Neovo
logo will be shown on the startup
screen.
Press the / button on the
control panel or the / button on the
remote control to select the setting.
Off
On
APM
If APM function is enabled and no
signal is detected, the LCD display
will automatically turn off.
Press the / button on the
control panel or the / button on the
remote control to select the setting.
Off
On
Information
OSD
When this function is enabled and
the display is turned on while in
standby mode, an information OSD
is displayed on the upper left corner
of the screen
.
Press the / button on the
control panel or the / button on the
remote control to select the setting.
Off
On
DisplayPort Ver.
Set the DisplayPort version to 1.1a
or 1.2. This setting is only valid on
DisplayPort input and output as
follows.
• 1.1a
: Switch DisplayPort Ver.
to 1.1a(default), then the
DisplayPort output is the clone
of the DisplayPort input.
• 1.2
: Switch DisplayPort Ver.
to 1.2 to support MST(Multi-
Stream Transport).
Note:
If the display is black screen
or abnormal under DisplayPort
source, please switch to 1.1a and
turn AC off and on.
Press the / button on the
control panel or the / button on the
remote control to select the setting.
1.1a
1.2