Ag Leader Technology
Cotton Picker Installation
CaseIH 2055
November 2002
2006200-1
9-19
Operational
Checkout
Refer to the Display Items section in the Operation Section for
instructions on how to display different items on the screen.
Step-by-Step
Procedure
1. Start
engine.
2. Verify the monitor powers up/down properly.
2a. Turn the monitor power switch ON and verify the monitor
powers up properly.
NOTE: The monitor will power up, check a box for each
sensor detected and display the harvest screen of four
selected items. If sensors cannot be located, confirm the
machine setup is correct by referring to Vehicle Setup in
the Operator's Manual. If the problem continues refer to
"Monitor Does Not Find Correct Number of Flow
Sensors on Initial Power Up" in the Troubleshooting
Section of this manual.
2b. Turn the monitor power switch OFF and verify the monitor
powers down properly.
NOTE: When the power switch is turned OFF the
monitor will not immediately turn OFF. The screen will
display "Now Archiving Data…" "Monitor will
automatically power down when complete". If the
monitor does not power up/down as described, re-check
the cable connections.
3. Display “Fan Speed” on the screen.
3a. Verify that Fan RPM stays at zero with the Fan OFF.
3b. Engage the fan and verify the monitor measures fan RPM.
It should increase as the engine speed engine increases all
the way too full engine spreed, if not re-check cable
connections.
