- 5 -
1
ON
Address “1” ON
1 OFF Address “1” OFF
2
ON
Address “3” ON
2 OFF Address “3” OFF
3
ON
Address “5” ON
3 OFF Address “5” OFF
SET
When use different remote
control
CLEAR
Automatically clean material for 3
seconds
5 S
All units work during 5
seconds
15 S All units work during 15 seconds
30 S
All units work during 30
seconds
OFF
All stop
Attention :
The first group machines correspond to DMX address “1”, the second group DMX address is “3”, the third DMX address is “5”,
remote controller controls 3 group machines. It also can set all unit’s addresses as “1”.
When the lamp is not lit or become weak on the remote controller, replace the battery. It is better to take battery out when
transporting to prevent consumption of battery power by unmeant press of button.
Battery model
：
12V 23A
When the machine is occasionally not working, may be caused by interference, please press the start button again.
Wireless control is easily influenced by interference, it is recommended to stay as close as possible to the machine when using
the remote control, and machines cannot use metal shielding.
Master mode (requires XLR cables):
In case of strong interference, the Master-slave mode might be a solution. Set the DMX address of the first unit to “1++”. The
address of this unit is “1” but it can also supply a DMX output signal and become a Master. Daisy-chain the other units via XLR
cables. The master unit receives the signal from the remote control and sends it to all others of the chain.
Cable DMX mode :
When using the DMX controller, the system takes 2 channels
The First channel
Functions
0-15
Fountain OFF
16-255s
Fountain ON
The second channel
Functions
60-80
Clear Material
20-40
Emergency Stop
0-10
Pre-heat OFF
240-255
Pre-heat ON