© Copyright LOTRONIC 2016 BEAM1R
Page 12
60-79
LAMP OFF
Lamp switch passing through the unused range and
staying 5 seconds.
40-59
Lamp ON
0-39
UNUSED RANGE
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION
: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure
that the light is power off before dismantling or maintaining, it’s very important to keep the light
clean. Frequent cleaning will ensure maximum brightness output, but also prolong the life time
. It’s suggested to use
the high quality, professional glass
detergent and soft cloth to clean the light. It’s not allowed to use alcohol or
chemical solvent. The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn’t work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.
If the light’s lens damaged or broken, and should need change the new lens, if the bulb damaged or have any
deformation, make the light dim, it says that the bulb had run out of its life., should change in time. There are 3
thermal protection devices, using for cut off the lights power when it is heating. If the thermal protection device set up,
and then need to check whether the fan is normal.
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.